Or you can send a track straight to the master and also to the parallel. Now you could for example send your drum tracks to this bus also. If you wanna use a compressor in parallel, set that up on another buss. In this case uncheck the MSTR assignment on the tracks. If you wanna process all your drum tracks together, route them to one of the busses and consider this your drum group on which you can process the whole kit. Basically, you should decide whether you wanna use the busses as groups, parallels or FX. If you leave a track assigned to the Master and also send it through one of the mixbusses, yes, it will get louder as it now arrives at the master two times. So, if I send a track to a Mixbus should I also disable its "Mstr" button?You first need to understand the workflow. I think what's happening is that the track is routed through the Master channel (The "Mstr" button is enabled), then when I send it to Mixbus1 that also has "Master Buss Assign" enabled, so the Master channel is processing two copies of the same track. Also, any tips relating to the master limiter would be helpful! However, it would be good to know why routing the track through MixBus1 increased the level and caused the master limiter to come in. I wondered if the volume had increased, but the master channel vertical meter (the output volume?) doesn't change.Īctually, I've just noticed that there's a small horizontal bar meter in the master channel which says "Limit" and that is "In", so that's probably answered my question!
The audio is now also going through the MixBus channel, but as far as I can see, there's no EQ, compression, or gain settings on that channel (I didn't change anything from default). I can't work out what actually happened, and why the sound changed. It sounded a lot richer and punchier, and almost like it had some reverb.
I was listening to it, and I pressed the "MixBus 1" button on the track, and noticed that the sound immediately changed. I haven't made any EQ changes or anything. I've got MixBus 5 up and running, and I've imported a drum loop WAV file into a track. I've bought MixBus 5, and have started to watch the Groove3 training videos. I've been using Cubase, but I have next to no experience of using DAWs, and I only use the most basic of features.
0 kommentar(er)
